This solid carbide milling burr 4 x 6 x 60 mm is cut off one piece. It distinguishes itself through rough drilling features, due to its deep cuts, which also leads to a good chipping removal.
Special features:
Due to the reduction of a 6 mm drill burr to 4 mm at the tip, working time is reduced by more than half, for less material has to be cut. A pleasant side effect: the core drawing protection doesn’t have to be destroyed thanks to the small milling burr head diameter.
Technical features:
Material: Solid carbide
Form: cylindrical
d1: 4.0 mm
I1: 14.0 mm
d2: 6.0 mm
I2: 60 mm
Toothing: crossed toothing for unsiversal use
Coating: none
Application possibilities:
- tough and high-strength material
- alloyed steel casting
- synthetic material
- universal usage
- highest chip removal
Strongly recommended for the following materials:
- Brass
- Copper
- Cast iron
- Bronze
- Pure steel
- Hardened steel
- Stainless steel
- High-Grade steel
- Titan